ATR8-420-24L-MS NK Technologies Industrial Automation Components

Name: ATR8-420-24L-MS
Brand: NK Technologies

ATR8-420-24L-MS on Advantage Electric Supply

Part#:ATR8-420-24L-MS

Manufacturer:NK Technologies

Product Lifecycle:Active

Get a quick Quote!

ATR8-420-24L-MS True RMS Current Transducer, Split-Core, 24L - 24 VDC Loop-Powered

About the manufacturer: NK Technologies is one of the manufacturers that offers Industrial Automation Components that you can order at Advantage Electric Supply site. Maynard Kuljian founded Neilsen-Kuljian, Inc. in 1982 to address the demand for a more affordable way to measure current draw. The company was a trailblazer in creating cost-effective solid-state current sensing technology, which has since become a standard in the industry.

Check out the ATR8-420-24L-MS NK Technologies price in the box on the right side or send a quick quote.

Product Details

Shipping Weight
1.2 pounds
Sensor Type
AC Current Transducer, 4-20 MA Output Loop Powered
Range
0-800 amperes
Power Supply
12-32 volts, 24 volts
Output Signal
20 milliamps
Isolation Voltage
2000 volts
Output
23 milliamps
Flammability Class
UL 94V-0
Frequency
20/400 hertz
Certifications
CE, UL/cUL
Accuracy
1 percent

Product condition

New Factory Sealed

New Factory Sealed - New condition, never used, original OEM part with original packaging and factory seal.

ATR8-420-24L-MS Description

The ATR8-420-24L-MS Current Transducer combines a current sensing element and signal conditioner into a single package. The ATR8-420-24L-MS AC Current Transducer is True RMS for use on distorted waveforms found in VFD or SCR outputs. This AC Transducer produces a proportional 4-20ma analog output signal within a 0-800 amp range. The large, easy-to-install split-core design allows for installation over existing conductors without the need to disconnect the load, even in applications where there are multiple conductors per phase. Whether installing over existing conductors or in a new control system, installation is very simple and quick. Just remove the top portion of the sensing ring, place the conductors inside, and snap the top back in place. The transducer uses two wires to connect to the power supply or the load, (a programmable logic controller, a panel meter, or a data acquisition system). A 24VDC loop powered power supply is required.